Elemental Workshop II



Quest Difficulty: Novice
Quest Length: Short

Description: Among the ancient scrolls and papers held at the Dig Site's Examination Centre, scholars have discovered more references to the mysterious elemental ore. Recently they have uncovered a beaten book detailing long-lost uses for this odd material.

Can you decrypt the code that will lead you to the deeper depths of the Elemental Workshop? Can you get your head around fixing the mind-bending machinery, or will you fry your brain in the attempt?

Requirements:
Level 20 Magic
Level 30 Smithing


Items Required: Battered Key, Hammer, Pickaxe, and 2 Elemental bars (make using 8 Coal and 2 Elemental ores). Teleport runes to Camelot are also recommended.

Reward:
7500 Crafting XP,
7500 Smithing XP,
Ability to make and use elemental mind equipment,
1 QP


Start Point: Exam Centre at the Dig Site

Quest Guide:

1.) To start the quest, go to the Exam Centre near the Dig Site and search the bookcases until you find a Beaten Book. Start reading this book and then you should end up with a scroll in your inventory. Do not drop it. Keep it in your inventory. The reason for this is because if you do this, you won't be able to make the Elemental Helmet at the end of the quest as your reward. Read the scroll or just look at it and then stop reading it and now you will have to be on your way to Seers Village.


2.) Once you're at Seers Village, you will need to go to the Elemental Workshop. Use your Battered Key from the first quest to go past the odd wall. (If you don't have the key anymore, you will have to go to the bookshelf in the other house and use the same procedures to get the key again as in the last quest.



3.) Once you're down in the Workshop, go into the north room and search the Machinery Water Elementals for a key.


4.) Go back to the Centre room in the Dungeon. Use the key you have with the hatch on the floor.



5.) In this area of the workshop, you will need to repair some machinery in order for you to make your new type of elemental bar. The machines in this room that need repairing are the tank, the press, the crane, and the wind tunnel. Start searching the crates in this room on the floor until you end up with a large cog, a medium cog, a small cog, a crane schematic, a lever schematic, and a pipe. One of these items at random will be located upstairs on the new floor. Walk up some stairs that are north-east of you. Here you should see a jagged path that goes around the lava pit. Start searching the boxes until you find one of the items you didn't find downstairs.


6.) Now go to the broken pipes and use your pipe with the broken piping. The pipe should be on the catwalk upstairs near the northern area.


7.) You will now need to fix the press. To do this, go upstairs and go to the western side of the area. You will need to connect the top left socket to the bottom right socket, connect the top middle socket to the top right socket, and then connect the bottom left socket to the bottom middle socket.



8.) Now you will need to fix the crane using two Elemental bars. You will now need to exit the room and go back to the Elemental Workshop. Up here, use your Elemental Bar with and anvil and make a claw.

9.) Go back down to the new room with the crane in it. Go to the southern area of the room now near the crane and then pull the leaver. The crane should then come closer to you. If not, don't worry. Once you've done that, go and use your claw in your inventory with the Old Crane to fix it.



10.) Go to the eastern side of the room to fix the wind tunnel and use the large cog on the far right pin, the Medium Cog on the lower left pin, and the Small cog on the upper left pin. Go back to the crane once you've done this.


11.) Now go to the northern area of the room and pull the lever until the Jig Cart appears under the Crane. Now place your second Elemental Bar you have on the Jig Cart.


12.) Now go to the leaver which should be near the western side of the Jig Cart and pull it twice. The Claw should now pick up the bar. Go east of the Jig Cart to find another leaver and pull it once which should make the bar go over the lava. Now go and pull the leaver west of the Jig Cart twice so that the bar enters the hot lava. Now pull the leaver which is east of the Jig Cart so that the bar comes back to the Jig Cart. Now you'll have to put the bar back onto the Jig Cart. To do this, pull the leaver west of the Jig Cart.

13.) Now you'll have to get the cart to go to the stamp machine. To do this, pull the leaver in the northern area so that it moves there. Now there should be another leaver near by. Pull this one to make the bar become flat.


14.) Now you'll need to go north and open the tank doors using the old leaver. Start turning the corkscrew leaver twice. Now close the tank door using the old leaver again and then turn the water valve once, then the east valve, then the west one again. Now pull the old leaver again once you've drained out the water and the elemental bar has turned blue. Turn the corkscrew lever twice, then pull the old lever.



15.) Now start to move the Jig Cart again onto the next machine. The bar should then turn white as the machine will blow air on it. Turn the leaver again so that it turns off the fan and then move it to the crane again. Pick up the bar which should now be Primed.

16.) Go down some stairs and you should see some doors with pictures of mind runes on them. Go through those doors.

17.) Once you're inside, place your mind bar under the extractor gun. Use the extractor hat and then you should have your new Primed mind bar.



18.) Go upstairs and make yourself an Elemental Mind Helmet out of the bar.

Congratulations! You will have now completed this quest.

Guide made by: Chas433, Gerrard
.